how to clean laser lens on dvd player

How to Clean Laser Lens on DVD Player

As you might have noticed, your DVD player might not be functioning as well as it used to. This might be due to dust and debris that have accumulated on the laser lens of the player. However, cleaning the laser lens is not as technical as it sounds. You can do it yourself with readily available materials at home. This article walks you through easy to follow steps on how to clean your DVD player laser lens.

1. Disconnect the DVD Player

Before you start cleaning, make sure your DVD player is turned off and has been disconnected from any power sources. This is an essential safety procedure that ensures you do not get hurt or electrocuted in the process.

2. Access the Laser Lens

Take off the outer casing of the DVD player. Depending on the model of your DVD player, you might be required to remove screws or clips that hold the casing in place. Ensure that you put the removed screws and clips aside in a secure place for easy reassembling.

Upon opening the casing, locate the DVD player laser lens. It is a small, clear plastic lens that reads the discs. Use a flashlight to spot the lens easily.

3. Extend the Laser Lens

Many DVD players have an extendable laser lens that comes out when you open the DVD tray. Gently pull the lens out while holding the gears located behind it. Carefully extend the lens until you see its edges.

If the lens isn't extendable, you do not need to worry. You can still access and clean it in a similar way.

4. Clean the Laser Lens

Now that you have access to the laser lens, you can start cleaning it. The most recommended way to clean a laser lens is by using a microfiber cloth. A microfiber cloth is safe to use on the lens because it does not leave particles that could damage the lens or affect the reading process.

Dampen the microfiber cloth with a small amount of isopropyl alcohol or distilled water. Do not use tap water as it contains minerals that can damage the lens. Use a circular motion to clean the lens gently. Be careful not to touch the lens with your fingers as it will leave fingerprints.

5. Reassemble the DVD Player

After cleaning the lens, let it air dry for a few minutes. Then, use a clean microfiber cloth to remove any residual moisture on the lens. Use your fingers to push the laser lens back into its usual position. Once done, put the outer casing back in place and secure it with screws or clips.

6. Test the DVD Player

Connect the power source to the DVD player and turn it on. Test it with a DVD to see if it reads the disc correctly. If your DVD player still reads the disc incorrectly or not at all, you might have to consider a thorough cleaning or seek professional help.

In conclusion, cleaning the laser lens of your DVD player is an essential process that helps maintain the player's functionality. It is a simple process that you can handle yourself with the right materials and procedure. Follow the above steps carefully, and you will be amazed at the results.