how to replace the ps3 blu-ray drive laser lens

2023/06/19

Introduction

If you’re a proud owner of a PlayStation 3 and love playing games on it, you must know how important it is to have a working Blu-ray Drive Laser Lens. The Blu-ray laser is an essential component of the PS3, which reads and plays your favourite games, movies, and music CDs. But, with regular use, the laser may get damaged, affecting your gameplay. In such cases, you need to replace the drive laser to continue playing your favourite PS3 games. However, replacing the PS3 Blu-ray Drive Laser Lens is no walk in the park. It can be tricky and complicated. In this article, we’ll guide you through the process of replacing the PS3 Blu-ray Drive Laser Lens.


Tools Required

Before we start, you'll require the following tools:

1) A parallel Phillips screwdriver

2) A small flathead screwdriver or something with a prying edge

3) A pair of pliers

4) A pair of tweezers

5) A replacement PS3 Blu-ray Drive Laser Lens


Step-by-Step Guide to Replace the PS3 Blu-Ray Drive Laser Lens


Step 1: Open the PS3 Cover

Power off the PS3 and unplugged all cables. Utilizing the prying edge, carefully lift the warranty seal present on the right-hand side of the PS3's cover. Remove the rubber feet from the four corners below, exposing the screws.


Step 2: Remove the Screws

Use the parallel Phillips screwdriver to remove the screws. Be careful not to drop the screws into the PS3 as they may cause damage.


Step 3: Remove the Cover

After removing all the screws, gently lift the cover of the PS3. Be sure to disconnect the ribbon cable on the right-hand side by sliding the ribbon out of the connector.


Step 4: Remove the Blu-ray Drive

Once the cover’s removed, we need to take out the Blu-ray drive. Remove the screws that hold the Blu-ray drive in position, and then gently disconnect the ribbon connectors from the Blu-ray drive. Once the ribbon cable is disconnected, remove the Blu-ray drive from the PS3.


Step 5: Replace the PS3 Blu-ray Drive Laser Lens

To replace the PS3 Blu-ray Drive Laser Lens, we’ll have to remove the top cover of the drive. Remove the screws from the top cover by using the Phillips screwdriver. Once removed, gently lift the cover and place it aside. The laser lens is held in position by two small screws. Use the Phillips screwdriver to remove these screws, and then gently slide the lens housing towards you. The laser’s ribbon cable is still connected to the Blu-ray drive, so be gentle not to puncture it.


With the laser exposed, use the pliers to remove the lens from the housing. Once removed, gently insert the replacement lens into the housing, ensuring that it’s firmly in place.


Step 6: Reassemble the PS3

After replacing the PS3 Blu-ray Drive Laser Lens, it's time to reassemble your PS3. Follow steps four to one in reverse order to reassemble the PS3. Ensure the ribbon cables are correctly connected and the screws are in their original positions.


Conclusion

Replacing the PS3 Blu-ray Drive Laser Lens isn't easy, but it's not impossible. With this guide, you'll be able to replace the laser lens without any issues. Just make sure you have the required tools and follow each step of the guide correctly. Remember, a functional PS3 Blu-ray Drive Laser Lens is essential for seamless gameplay, so don't compromise on its quality.

.

CONTACT US
Just tell us your requirements, we can do more than you can imagine.
Send your inquiry
Chat
Now

Send your inquiry

Choose a different language
English
Current language:English